High Output Stator 300 W Stator Cover Gasket Yamaha Raptor/Warrior/Wolverine 350 / Big Bear 400 2000–2013

High Output Stator 300 W Stator Cover Gasket Yamaha Raptor/Warrior/Wolverine 350 / Big Bear 400 2000-2013

• Top Quality Products
• Direct replacement to your original unit
• Plug-and-play, direct fit, easy installation.
• Highest grade lamination materials
• Highest grade copper windings, resistant to 200 degrees Celsius.
• Pick up pulsar coil included
• Connector included
• Rubber grommet included
• Gasket included
• All product shipped are tested

Fits Models

• Yamaha
  • Raptor 350 2000-2013
  • Warrior 350 2000-2013
  • Wolverine 350 2000-2013
  • Big Bear 400 2000-2013

Technical Details

Number of wires : 7
Number of terminals : 7
Alternator : White between each White = 0.4 ohms+/-20%
Alternator : White to Ground = O.L. ON DISPLAY
Pick up : Green to Blue = 450 ohms+/-20%
Position Sensor : Orange to White/Blue = 0.2 ohms+/-20%
Interior Diameter : 53mm
Exterior Diameter : 115mm
Thickness: 24mm

Before installing your new stator

• Check the AC output of the stator.
• Replace any burned or corroded connectors on stator and regulator/rectifier
• Check and repair any melted wiring.
• Use hi-temp dielectric grease on all connectors

Our stator may use a different wire color code than your original.
All of the wires are installed in the correct order; please do not change any of the wiring configurations.
This stator is designed as a direct plug-in replacement and should be used as such.

When bolting stator in, always use locking compound.
If our stator includes a pickup coil, always make sure the air gap is correct upon installation; we suggest as close as possible no less than 0.010?.

Part Application/Fitment

Interchanges/Cross References