Stator Polaris Sportsman 600 Carb 2003–2005 Sportsman 700 Carb 2002 2004–2006

Stator Polaris Sportsman 600 Carb 2003-2005 Sportsman 700 Carb 2002 2004-2006

• Direct replacement to your original unit
• Plug-and-play, direct fit, easy installation.
• Highest grade lamination materials
• Highest grade copper windings, resistant to 200 degrees Celsius.
• Pick up pulsar coil included
• Connector included
• Rubber grommet included
• Back Plate included
• Adjustable timing plate to advance and retard up to 10 degrees included
• All product shipped are tested
• One year limited warranty

*The Sportsman 600/700 2004 have more than one potential stator.

We have even included the opposite connector (main harness side) as we know these are often melted/corroded/defective and a major cause for repetitive electrical issues.

*All item pictures are accurate; if in doubt do not hesitate to compare our item to your original part.

Fits Models

• Polaris Sportsman 600 2003 -2005
• Sportsman 700 2002 -2003
• Sportsman 700 4×4 Carb 2004 -2004
• Sportsman 700 4×4 Carb 2006 -2006
• Sportsman 700 Carb 2005 -2005

Replaces OEM

• 2202602
• 2202603
• 4010709
• 4010901
• 4011103
• 4060150

Technical Details

Number of wires : 10
Number of terminals : 10
Alternator: Yellow to Yellow/Red = 0.7 ohms+/-20%
Alternator : Yellow to Ground = O.L. ON DISPLAY
Pick up 1 : Red to Black 470 ohms+/-20%
Source 1 : Brown to Yellow 10 ohms+/-20%
Before installing your new stator

• Check the AC output of the stator.
• Replace any burned or corroded connectors on stator and regulator/rectifier
• Check and repair any melted wiring.
• Use hi-temp dielectric grease on all connectors

Our stator may use a different wire color code than your original.
All of the wires are installed in the correct order; please do not change any of the wiring configurations.
This stator is designed as a direct plug-in replacement and should be used as such.

When bolting stator in, always use locking compound.
If our stator includes a pickup coil, always make sure the air gap is correct upon installation; we suggest as close as possible no less than 0.010?.

Part Application/Fitment

Interchanges/Cross References