Stator Coil – Arctic Cat 250 /300 4×4 Generator | Arctco OEM 3430–021

Stator Coil – Arctic Cat 250 /300 4×4 Generator | Arctco OEM 3430-021

• Direct replacement to your original unit
• Plug-and-play, direct fit, easy installation.
• Highest grade lamination materials
• Highest grade copper windings, resistant to 200 degrees Celsius.
• Pick up pulsar coil included
• Connector included
• Rubber grommet included
• All products shipped are tested
• One year limited warranty

All item pictures are accurate; if in doubt do not hesitate to compare our item to your original part.

Fits Models

• Arctic Cat 250 1998 -2005
• 300 1998 -2005

Replaces OEM 

• 3430-021

Technical Details

Dimensions :
Interior diameter : 41mm 
Exterior diameter : 102mm 
Thickness : 16mm 
Length of wires stator to grommet : 40mm 
Length of wires grommet to plug : 290mm 
Length of pickup coil’s wire to grommet : 20mm 

Other specifications :
Number of wires : 5 
Number of plugs : 2 
Number of pins : 5 

Wire to wire resistance :
Alternator : Yellow between each Yellow = 0.4ohms +/-20%
Pickup : Blue to Green = 116ohms +/-20%

Before installing your new stator

• Check the AC output of the stator.
• Replace any burned or corroded connectors on stator and regulator/rectifier
• Check and repair any melted wiring.
• Use hi-temp dielectric grease on all connectors

Our stator may use a different wire color code than your original. `
All of the wires are installed in the correct order; please do not change any of the wiring configurations.
This stator is designed as a direct plug-in replacement and should be used as such.
When bolting stator in, always use locking compound.
If our stator includes a pickup coil, always make sure the air gap is correct upon installation; we suggest as close as possible no less than 0.010’’.

Part Application/Fitment

Interchanges/Cross References